Required Equipment

For this procedure, you will need the following equipment:

• #2 Phillips (cross-head) screwdriver

• Marker or tape to indicate a level plane on which the stand-off brackets will be installed

• Four (4) M6 cage nuts

• Four (4) M6 x 16 mm screws

• Four (4) 10-32 x .375 inch Phillips pan-head screws

• Four (4) 12-24 x .5 inch Phillips pan-head screws

• Four (4) #12 locking washers (for use with 12-24 screws)

• Four (4) M4 x 10 mm Phillips flat-head screws

  ---

  Note - Oracle provides four of each type of screw for mounting the CMA to the rack. The type of screw that you will use depends on the type of rack you have. For example, if you have a Sun/Oracle rack, you will use the M6 cage nuts and the M6 screws to attach the CMA to the rack. Be aware that you will not use every type of screw, just the type appropriate for your equipment rack.

  ---