Fibre Channel I/O Module LED Codes
The Fabric Interconnect supports the 2x8 Line-Rate FC Module
which provides 2 ports.
Note - The 2x8 FC Module is supported on InfiniBand DDR Fabric
Interconnects only. Do not install this module in a Fabric Interconnect
running an SDR InfiniBand fabric.
LED Codes — Fibre Channel Module shows the Fibre Channel
I/O module LED codes.
Figure 41 LED Codes — Fibre
Channel Module
These are general LED codes for the entire module:
|
|
|
Blinking green |
Blinking green |
I/O card is running diagnostics |
Off |
Blinking green |
I/O card is booting |
Off |
Solid green |
I/O card is up/running |
Off |
Solid amber |
Fault detected |
Solid blue |
Solid green |
I/O card is down (power to card is off) |
Blinking blue |
Solid green |
I/O card is shutting down |
|
These are specific LED codes for each Fibre Channel:
|
|
|
|
Off |
Off |
Off |
Power off |
On |
On |
On |
Power on (before FC initialization) |
Flash Simultaneously |
Power on (after FC initialization) |
Flash in series: yellow,
green, amber |
FW fault |
Off |
Off |
On |
1 Gb link up/active |
Off |
On |
Off |
2 Gb link up/active |
On |
Off |
Off |
4 Gb link up/active |
|