Remove a Fabric Interconnect F1-15 Management Module

On a Fabric Interconnect F1-15, the Management module can only be installed in slot 16, which is labelled M.

To remove the Fabric Interconnect F1-15 Management module, follow this procedure:

1. Power down the Fabric Interconnect.
2. Disconnect any cables attached to the Management module.
3. Using the screwdriver, release the spring-loaded securing screw (1), located at the bottom edge of the module. See Removing the Fabric Interconnect F1-15 Management Module.
4. Grasp the handle (2) and withdraw the module from the chassis.

   Figure 95  Removing the Fabric Interconnect F1-15 Management Module