CLI を使用した FC ポートの検出

• FC ポートを検出するには、次の CLI コマンドを使用します。

  dory:configuration san fc targets> show
  Properties:
                        targets = wwn.2100001B32811639,wwn.2101001B32A12239
  Targets:
  NAME       MODE       WWN                     PORT                 SPEED
  target-000 target     wwn.2100001B32811639    PCIe 5: Port 1       4 Gbit/s
  target-001 initiator  wwn.2101001B32A11639    PCIe 5: Port 2       0 Gbit/s
  target-002 initiator  wwn.2100001B32812239    PCIe 2: Port 1       0 Gbit/s
  target-003 target     wwn.2101001B32A12239    PCIe 2: Port 2       0 Gbit/s
  dory:configuration san fc targets> select target-000
  dory:configuration san fc targets target-000> show
  Properties:
                            wwn = wwn.2100001B32811639
                           port = PCIe 5: Port 1
                           mode = target
                          speed = 4 Gbit/s
               discovered_ports = 6
             link_failure_count = 0
             loss_of_sync_count = 0
           loss_of_signal_count = 0
           protocol_error_count = 0
          invalid_tx_word_count = 0
              invalid_crc_count = 0
  Ports:
  PORT      WWN                   ALIAS              MANUFACTURER
  port-000  wwn.2100001B3281A339  longjaw-1          QLogic Corporation
  port-001  wwn.2101001B32A1A339  longjaw-2          QLogic Corporation
  port-002  wwn.2100001B3281AC39  thicktail-1        QLogic Corporation
  port-003  wwn.2101001B32A1AC39  thicktail-2        QLogic Corporation
  port-004  wwn.2100001B3281E339  <none>             QLogic Corporation
  port-005  wwn.2101001B32A1E339  <none>             QLogic Corporation