This is a client-side condition which compares the time that a visitor has been on the current page of the website against a specified value. For the purposes of this condition, the time that the visitor has been on the current page is calculated as the difference between the current time and the time that the ATGSvcs library was loaded. This is measured in milliseconds, although for simplicity you enter the comparison time in seconds.
The following configuration options are available for this condition:
Operator: This is used to specify the type of comparison to perform.
Time: This is used to set the value against which to compare the time the visitor has spent on the page. You can define the time in hours, minutes, and seconds using the text boxes.
Note: If a visitor has a slow connection and you select “less than” from the Operator dropdown, it is possible that the time taken to load the rules on the page and then run the rules will exceed the value specified, particularly if the value is low. You should bear this in mind when defining this value, or if you are trying to find out why a rule configured this way did not behave as expected.
