-
Select Device Settings → Date/Time.
-
For the Time Zone, select your time zone.
-
If the daylight saving time applies to your time zone, verify that
Automatic Daylight Saving Time Adjustment is selected.
If the daylight saving time rules do not apply to your time zone, clear
the Automatic Daylight Saving Time
Adjustment check box.
-
Select the method for setting the date and time.
-
To customize the date and time:
-
Select User Specified Time.
-
For the Date, type values using the yyyy-mm-dd format, or click
the Up arrow or Down arrow and select a date.
-
For the Time, type values using the hh:mm:ss format, or click the
Up arrow or Down arrow to adjust values.
The time is measured in a 12-hour format and so you must specify
AM or PM by clicking the AM or PM button.
-
To set the date and time using the NTP server:
-
Select Synchronize with NTP Server.
-
Assign the NTP servers in either of the following ways:
-
Click Save.
The HPDU follows the NTP server sanity check per the IETF RFC. If the HPDU
cannot synchronize with a Windows NTP server, see Windows NTP Server Synchronization Solution.