After selecting DHCP as the IPv4 configuration mode, optionally, to
specify the preferred host name, at the config:# prompt, type
network ipv4 interface <ETH> preferredHostName
<name> or network ipv6 interface <ETH>
preferredHostName <name>, and press Enter.
<name> is a host name which:
Consists of alphanumeric characters and/or hyphens
Cannot begin or end with a hyphen
Cannot contain more than 63 characters
Cannot contain punctuation marks, spaces, and other symbols
IPv4 Network Interface
Description
ethernet
(PDU)
Determine the IPv4 or IPv6 preferred host name of the
ETHERNET interface (wired networking).
eth1
(PDU -iX7)
Determine the IPv4 or IPv6 preferred host name of the
ETH1 interface (wired networking).
eth2
(PDU -iX7)
Determine the IPv4 or IPv6 preferred host name of the
ETH2 interface (wired networking).
bridge
Determine the IPv4 or IPv6 preferred host name of the
Bridge interface (Bridging mode).
Note -
Be sure to configure the bridge. In Bridging mode,
only the IP parameters of the Bridge interface
function. The IP parameters of the ETHERNET (or
ETH1/ETH2) and WIRELESS interfaces do not
function.