Oracle^® Rack Universal Power Distribution Unit User's Guide

Configuring Wired Network Settings

1. On the Network page, click the ETHERNET (or ETH1/ETH2) section to configure IPv4/IPv6 settings.
2. To enable the Interface, ensure the Ethernet interface is enabled, or all networking through this interface fails. This setting is available in the ETHERNET (or ETH1/ETH2) section.
3. For IPv4:
   1. Enable or disable the IPv4 protocol.
   2. To select the method for IP Auto Configuration, select DHCP (automatic) or Static (manual).
   3. If you select DHCP, optionally, specify the preferred hostname.

      The hostname consists of alphanumeric characters and hyphens, cannot begin or end with a hyphen, with a maximum of 63 characters, and no punctuation marks, spaces, and other symbols.

   4. If you select Static, assign a static IPv4 address, with the syntax IP address/prefix length. For example, 192.168.84.99/24.
4. For IPv6:
   1. Enable or disable the IPv6 protocol.
   2. To select the method for IP Auto Configuration, select Automatic or Static (manual).
   3. If you select Automatic, optionally, specify the preferred hostname.

      The hostname consists of alphanumeric characters and hyphens, cannot begin or end with a hyphen, with a maximum of 63 characters, and no punctuation marks, spaces, and other symbols.

   4. If you select Static, assign a static IPv6 address, with the syntax IP address/prefix length. For example, fd07:2fa:6cff:1111::0/128.