Oracle^® Rack Universal Power Distribution Unit User's Guide

Viewing Inlet I1

The number of phases that display in the Inlet section is dependent on the HPDU model.

• To view more information or configure an inlet, click Inlet I1 to go to the Inlet page.

  The left side of the Inlet dashboard shows all or some of the following generic inlet power data:

  • Active power (kW or W)

  • Apparent power (kVA or VA)

  • Active energy (kWh or Wh)

  • Power factor

  • Line frequency (Hz)

  • Unbalanced current (%) - Dependent on the HPDU model

  The right side of the Inlet dashboard shows the current and voltage data per phase. For a single-phase device, only one line displays, and for a three-phase device, three lines (L1, L2 and L3) display.

  The other Inlet data includes:

  • RMS current (A) and rated current

  • Smaller, gray text next to RMS current is the rated current.

  • Bar showing the RMS current level

  • RMS voltage (V)

  The RMS current bars automatically change colors to indicate the current status if the thresholds are enabled.

  • Green – Normal

  • Yellow – Above upper warning

  • Red – Above upper critical

  ---

  Note -  The below lower warning and below lower critical states also show yellow and red colors, respectively. However, it is not meaningful to enable the two thresholds for current levels.

  ---