Oracle^® Rack Universal Power Distribution Unit User's Guide

Connecting the Input Cord and To a Power Source

1. Secure the input cord to the HPDU by using the captive screws with a #2 Philips screwdriver and torque to 15 in-lbs (1.7 Nm).
2. Connect the other end of the input cord to an appropriately rated branch circuit.

   ---

   Note -  For the input ratings or range of ratings, refer to the label or nameplate on the HPDU input power cable.

   ---

3. Set all circuit breakers to ON.
4. To power cycle the HPDU, unplug it from the branch circuit, wait 10 seconds, and plug it back in.

   When the device powers up, a power-on self test runs and software loads for a few minutes.

   When the software finishes loading, the front panel display illuminates.