To show the specified network interface information that is not related to
IP configuration, for example, the Ethernet port LAN interface speed and
duplex mode, or the wireless interface SSID parameter and authentication
protocol, type show network interface <ETH>, and press
Enter.
<ETH> is one of the network interfaces: ethernet (or ETH1/ETH2),
wireless, or bridge. For details, see the following table.
Note -
If the HPDU is set to the bridging mode, select and configure the
bridge interface.
Interface
Description
ethernet
(PDU)
Show the ETHERNET interface non-IP settings.
eth1
(PDU -iX7)
Show the ETH1 interface non-IP settings.
eth2
(PDU -iX7)
Show the ETH2 interface non-IP settings.
bridge
Show the BRIDGE interface non-IP settings.
all
Show the non-IP settings of all interfaces.
You also can type the command without the
all option to get the same data.
For example, show network ip
interface.