Oracle^® Rack Universal Power Distribution Unit User's Guide

Configure the HPDU Device and Network

1. Log in as the administrator so that you have full permissions.
2. At the # prompt, to enter configuration mode, type config, and press Enter.

   ---

   Note -  Configuration commands are case sensitive. Be sure to capitalize them correctly.

   ---

   Configuration commands function in configuration mode only.

   ---

   Note -  If you enter Configuration mode from User mode, you might have limited permissions to make configuration changes.

   ---

3. At the config:# prompt, type any configuration command, and press Enter to change the settings.

   ---

   Note -  To apply new configuration settings, you must type the apply command before closing the terminal emulation program. Closing the program does not save any configuration changes.

   ---

4. To save the changes and quit Configuration mode, at the config:# prompt, type apply, and press Enter.

   • apply command – Saves all changes you made and quits Configuration mode.

   • cancel command – Allows you to abort the changes you made and quit Configuration mode.

   The # or > prompt appears after pressing Enter, indicating that you have entered the administrator or user mode.