Oracle^® Rack Universal Power Distribution Unit User's Guide

Configuring Ethernet Interface Settings

The Ethernet Interface setting is available in the ETHERNET (or ETH1/ETH2) section.

1. Ensure the Ethernet interface is enabled, or all networking through this interface fails.
2. Change the Other Ethernet settings, if needed.

   Ethernet Interface Setting Description Speed Select a LAN speed. Auto: System determines the optimum LAN speed through auto-negotiation. 10 MBit/s: Speed is always 10 Mbps. 100 MBit/s: Speed is always 100 Mbps. 1 GBit/s MBit/s: Speed is always 1 Gbps. Note -  Auto-negotiation is disabled after setting both the speed and duplex settings of the HPDU to NON-Auto values, which might result in a duplex mismatch. Duplex Select a duplex mode. Auto: The HPDU selects the optimum transmission mode through auto-negotiation. Full: Data is transmitted in both directions simultaneously. Half: Data is transmitted in one direction (to or from the HPDU device) at a time. Note -  Auto-negotiation is disabled after setting both the speed and duplex settings of the HPDU to NON-Auto values, which might result in a duplex mismatch. Current State Show the current LAN status, including the current speed and duplex mode.