Restarting the HPDU
You can reset the HPDU device to factory defaults, or restart the HPDU using the
CLI commands, which is not a factory default reset.
-
Ensure you have entered administrator mode and the # prompt is
displayed.
-
Type either of the following commands to restart the HPDU device.
-
At the # prompt, type reset unit or reset
unit/y.
-
If you entered the command without "/y" in Step 2, a message appears prompting
you to confirm the operation. Type y to confirm the reset.
-
Wait until the Username prompt appears, indicating the reset is
complete.
Note -
Note: If you are performing this command over a USB connection, re-connect
the USB cable after the reset is completed, or the CLI communications are
lost.