SPARC M8 and SPARC M7 Servers Service Manual

Install an eUSB Disk

1. Install the new eUSB disk.
   
   1. Position the new eUSB disk in the CMIOU (panel 1).

      Ensure proper pin engagement with connectors before pressing the eUSB disk in place.

   2. Tighten the green screw to secure the eUSB disk to the CMIOU (panel 2).
2. Reinstall the CMIOU cover and slide the cover forward until the latch clicks into place.
3. Reinstall the CMIOU you removed to access the eUSB disk.

   See Install a CMIOU.

4. If you have not already done so, connect to the host and restart it.

   Connect to the host console in a separate terminal session before starting the host to ensure that you can view all messages reported by the system.

   -> start /Servers/PDomains/PDomain_x/HOST/console
   Are you sure you want to start
   /Servers/PDomains/PDomain_x/HOST/console (y/n) ? y
   Connecting /Servers/PDomains/PDomain_x/HOST/console
   
   -> start /Servers/PDomains/PDomain_x/HOST
   Are you sure you want to start /Servers/PDomains/PDomain_x/HOST (y/n)? y
   hostname starting

5. Verify that the fault has been cleared and the replaced component is operational.

   See Verify That a Fault Has Been Cleared.

6. Return the replaced component to Oracle.

   See Prepare a Component for Return to Oracle.

Related Information

• Remove an eUSB Disk

• Understanding eUSB disks