SPARC M8 and SPARC M7 Servers Service Manual

Return a CMIOU to Oracle

1. Position the CMIOU in the inner container, ensuring that the connectors are properly protected.
   
   1. Install the protective connector cover, which you removed from the replacement CMIOU, on the CMIOU that you are returning to Oracle. You must install this cover on the CMIOU (panel 1).

      ---

      Caution  -  It is very important that you properly install the connector cover to prevent additional damage during shipping and aid Oracle in determining how the component failed. Ensure that the connector cover is fully engaged and centered over connectors.

      ---

   2. Ensure that the protruding end of the CMIOU latch is centered in the window of the inner container (panel 2).
   3. Place corrugated sheet on top of the CMIOU with the “Top Rear” marking on the rear of the chassis facing up. Ensure that the corrugated sheet extends over the connector (panel 3).
2. Close inner container and secure the container with tape.
   
   1. Fold the bottom and top flaps of the inner container over the CMIOU (panel 1).
   2. Fold the side flaps of the inner container over the CMIOU (panel 2).
3. Ensure that the outer container and packing cushions are assembled in the order shown.
   

   No. Step 1. Insert bottom corner cushions into outer shipping container. 2. Insert bottom center cushion on bottom of outer shipping container. 3. Position sealed inner shipping container on top of bottom center cushion. 4. Insert top center cushion on top of sealed inner shipping container.

4. Close the outer shipping container and seal it with the packaging tape supplied by Oracle.
   

Related Information

• Reseat a CMIOU

• Install a CMIOU