Install PCI-X 0-1 and PCIe 2-3 Cards
Before You Begin
Note - The maximum power of any one PCI
card is 25 watts. Only PCI-X Slot 4 and PCIe Slot 5 accept long
cards. PCIe Slots 2 and 3 are an exception and support 75 Watt PCIe
cards. However, only one 75 Watt card can be installed in the server
at one time. It is suggested to install the 75 Watt card in Slot
2 for better cooling.
- Prepare
the server for PCI card removal. See:
- Remove the PCI air duct.
Lift it straight up (Install PCI-X Cards 0-1 and PCIe Cards 2-3).
- Release the PCI card release
tab.
Pull it up and to the left (Install PCI-X Cards 0-1 and PCIe Cards 2-3).
- Remove the PCI card filler panel.
Lift it straight up (Install PCI-X Cards 0-1 and PCIe Cards 2-3).
Figure 4-3 Install PCI-X Cards 0-1 and
PCIe Cards 2-3
- Insert the PCI card in the appropriate
slot.
Carefully press it straight down until properly seated (Install PCI-X Cards 0-1 and PCIe Cards 2-3).
- Secure the PCI card release tab.
Press it down and to the right until properly seated (Install PCI-X Cards 0-1 and PCIe Cards 2-3).
- Replace the PCI air duct.
Carefully press it down until properly seated (Install PCI-X Cards 0-1 and PCIe Cards 2-3).
- See Returning the Server to Operation to
bring the server back online.