- Unpack
the replacement motherboard and place it on an antistatic mat (Install the Motherboard Into the Chassis).
- Lower the end closest the rear
of the server (Install the Motherboard Into the Chassis).
- Carefully slide the motherboard
1 inch (25 mm) toward the rear of the server, seating it into place
(Install the Motherboard Into the Chassis).
Figure 4-27 Install the Motherboard Into
the Chassis
- Align the motherboard assembly
screw holes over the chassis standoffs.
- Tighten the screws that attach
the motherboard to the chassis (Tightening the Motherboard Screws to the Chassis).
Figure 4-28 Tightening the Motherboard
Screws to the Chassis
- Reconnect the motherboard cables
(Reconnecting the Motherboard Cables).
Figure 4-29 Reconnecting the Motherboard
Cables
- Perform the tasks to bring the
server back online. See:
- Restore OpenBoot PROM variables
with one of the following procedures:
- For ILOM 3.0
Web Interface: Restore OpenBoot PROM variables per Chapter 10, “Backing
Up and Restoring ILOM Configuration,” from the Oracle
Integrated Lights Out Manager (ILOM) 3.0 Web Interface Procedure
Guide (820-0052) available at: http://docs.oracle.com/cd/E19860-01/index.html.
Use the same passphrase used during the back up to restore the OpenBoot
PROM variables.
- For ILOM 3.0 CLI: Restore OpenBoot
PROM variables per Chapter 10, “Backing Up and Restoring
ILOM Configuration,” from the Oracle Integrated
Lights Out Manager (ILOM) 3.0 CLI Procedure Guide (821-1611)
available at: http://docs.oracle.com/cd/E19860-01/index.html.
Use the same passphrase used during the back up to restore the OpenBoot
PROM variables.
- For ILOM 2.0: Use the data collected
during Step 1 of Remove the Motherboard Assembly to
restore the OpenBoot PROM variables with the OpenBoot PROM setenv command.
- Return the server to operation.
See Returning the Server to Operation.