|
|
|
Storage drive
|
-
Locate the storage drive filler panel to be removed from the
server.
-
To unlatch the storage drive filler panel, pull the release
lever, and then tilt the lever out into a fully opened
position.
-
To remove the filler panel from the slot, hold the opened
release lever, and gently slide the filler panel toward
you.
|
-
Locate the vacant storage drive module slot in the server,
and then ensure that the release lever on the filler panel is
fully opened.
-
Slide the filler panel into the vacant slot by pressing the
middle of the filler panel faceplate with your thumb or
finger.
The release lever will go in as it makes contact with the
chassis. Do not slide the filler panel in all the way. Leave the
filler panel out approximately 0.25 to 0.50 inch (6 to 12 mm)
from the opening.
-
Using your thumb or finger, press on the middle of the filler
panel faceplate until the release lever engages with the
chassis.
-
Close the release lever until it clicks into place and is
flush with the front of the server.
|
PCIe slot
|
-
Remove the server top cover.
-
To remove the PCIe slot filler panel, rotate the PCIe locking
mechanism, and then lift and remove the PCIe slot filler panel
from the location into which you intend to install the PCIe
card.
Note -
PCIe slots 1, 2, and 3 are nonfunctional in single-processor
systems.
|
-
Remove the server top cover.
-
To install the PCIe slot filler panel, press the PCIe filler
panel into the vacant PCIe slot, and then rotate the PCIe
locking mechanism to secure the PCIe slot filler panel.
|
|