Verifying that the System Is Ready for the Creation of VMs (CLI)

Language:

Note - Different versions of the MiniCluster software offer different mcmu commands and options. For the most accurate CLI information for the MiniCluster you are using, use mcmu help. See Display mcmu Help For All Subcommands (CLI) and Display mcmu Help for a Specific Subcommand (CLI).

Before you can create VMs, all of the system setup steps must be complete, and the state of the system software, drives, and connectivity must be in expected healthy state. The MCMU CLI provides a number of commands that enable you to verify various aspects of the system setup.

Note - To install and set up the system, refer to the Oracle MiniCluster S7-2 Installation Guide.

These topics describe how to verify the setup, and run readiness checks through the CLI.

List the System Setup Steps (CLI)
(If Needed) Run or Rerun System Setup Steps (CLI)
Verify the System Setup (CLI)
Verify the System, Topology, and Disk Readiness (CLI)
Ensure IP Addresses are Available in MCMU for Future VMs