Remove the DVD Drive or DVD Drive Filler Panel
When servicing the components in this section, unplug the AC power cords and use ESD protection.
 | Caution - Component damage. Ensure that all power is removed from the server before removing or installing the DVD drive. You must disconnect the power cables before performing this procedure. |
This procedure describes how to remove the DVD drive or a DVD drive filler panel.
Before You Begin
-
For serviceability considerations, see Component Serviceability.
-
Prepare for service.
See Prepare the Server for Cold Service.
To replace the DVD drive, the server must be disconnected from the power source.
-
At the front of the server, push down on the latch on the top left corner of the DVD drive or
filler panel.
-
Slide the DVD drive or filler panel out of the server.
Caution - Whenever you remove the DVD drive or filler panel, you should replace it with another DVD drive or a filler panel; otherwise the server might overheat due to improper airflow.
Next Steps