-> show /System/Open_Problems
-> show faulty
Note - The following lists are intended to show you how the procedures vary according to the type of component. For specific preparations, see the service procedures for specific components elsewhere in this document.
The command stops the component and lights the Ready to Remove LED.
I/O card carrier (PCIe low profile carrier)
At the server — Fault LEDs might be lighted on the front LED panel and rear LED panel.
On the component — See the component replacement procedure in this document for a description of the LEDs that might help you locate that component.
Ready to Remove LED — If the component has a blue Ready to Remove LED, the LED should be lighted before you remove the component. See Step 2.