Prior to cabling the server, prepare the cable routing brackets located at the top rear of the server. The left cable bracket secures the data cables, and the right cable bracket secures the power cords. Use these brackets to support and route the cables.
Note - The brackets have been installed at the factory with the left cable bracket facing upward and the right cable bracket facing downward. With this arrangement, the data cables out up through the top of the server and the power cords route down through the bottom of the server. You might need to reposition these brackets depending on how you plan to route the data cables and power cords.
If routing the power cords downward, leave the right cable bracket as is. Skip to Step 5.
If routing the power cords upward, remove the right cable bracket as described in the following steps.
Remove the right cable bracket from the server, and store the bracket and screws in a safe location.
If routing the data cables upward, leave the left cable bracket as is and skip to Step 8.
If routing the data cables downward, continue to the next step to reposition the left cable bracket.
Remove and save the bracket and screws for the next steps.