Go to main content

man pages section 1M: System Administration Commands

Exit Print View

Updated: July 2017
 
 

powertop(1M)

Name

powertop - report and analyze events that affect power management

Synopsis

powertop [-c processor_id] [-d count] [-t interval] [-v] [-h]

Description

PowerTOP is an observability tool that shows how effectively the system is taking advantage of the CPU's power management features. By running the tool on an otherwise idle system, the user can see for how long the CPU is running at dif- ferent power states. Ideally, an unutilized (idle) system spends 100% of its time running at the lowest power state, but because of background user and kernel activity (random software periodically waking to poll status), idle systems can consume more power than they should.

The tool analyzes system activity periodically and displays a summary of how long the processor is executing at each supported power state. It also displays the top activities responsible for causing the CPU to wake up and use more energy. This report allows the user to identify and diagnose problematic areas of the system and optimize its power efficiency.

PowerTOP averages the amount of activity that is preventing the CPU from entering a lower power state and presents it on the “Wakeups-from-idle per second” field. This value represents the total number of wake-ups divided by the current interval. Notice that not all events are displayed on the screen at all times.

During execution, a user can force a refresh of the analysis by pressing the R key. The interval time is restored to the default or to a specified value. To quit the application, the user must press the Q key.

PowerTOP runs on some virtual domains. However, the report for idle state transitions might or might not be accurate as the physical CPU can be shared by different virtual CPUs. Both wakeup count and event report displays information regarding the current virtualized environment.

Options

The following options are supported:

–c [processor_id]

Specifies which CPU the tool should observe.

–d [count]

Dumps the results of count analysis of system activity to the screen.

–h

Displays the command's usage.

–t [interval]

Specifies the interval, in seconds, at which the tool analyzes the system. The possible values are in the range of 1 through 30; the default is 5 seconds.

–v

Switches to verbose mode, including noting firings of the kernel cyclic subsystem in the event report.

Examples

Example 1 Setting the Interval

The following command sets the interval to two seconds.

% powertop -t 2
Example 2 Analyzing and Dumping System Activity

The following command analyzes and dumps system activity to the standard output four times.

% powertop -d 4
Example 3 Reporting Cyclic Subsystem Activity

The following command reports cyclic subsystem activity.

% powertop -v
Example 4 Analyzing Activity on a Specific Processor

The following command runs PowerTOP and only displays data for CPU 3:

% powertop -c 3

Exit Status

0

Successful operation.

1

An error occurred.

2

Incorrect usage.

Attributes

See attributes(5) for descriptions of the following attributes:

ATTRIBUTE TYPE
ATTRIBUTE VALUE
Architecture
x86, SPARC
Availability
diagnostic/powertop
Interface Stability
Volatile

See Also

kstat(1M), psrinfo(1M), uadmin(2), libdevinfo(3LIB), attributes(5), cpr(7), pm(7D), pm-components(9P), removable-media(9P)

Among non-SunOS man pages, xscreensaver(1).

Usage

You must have DTrace privileges to run PowerTOP.