sg_rtpg - man pages section 1M: System Administration Commands

Language:

sg_rtpg (1m)

Name

sg_rtpg - sends a SCSI REPORT TARGET PORT GROUPS command

Synopsis

sg_rtpg  [--decode]  [--help]  [--hex]  [--raw] [--verbose] [--version]
DEVICE

Description

SG_RTPG(8)                         SG3_UTILS                        SG_RTPG(8)



NAME
       sg_rtpg - sends a SCSI REPORT TARGET PORT GROUPS command

SYNOPSIS
       sg_rtpg  [--decode]  [--help]  [--hex]  [--raw] [--verbose] [--version]
       DEVICE

DESCRIPTION
       Send a SCSI REPORT TARGET PORT GROUPS command to DEVICE and outputs the
       response.

       Target  port group access is described in SPC-3 found at www.t10.org in
       section 5.8 (in rev 21c dated 2005/1/15). The Report Target Port Groups
       command is also described in that document.

OPTIONS
       Arguments to long options are mandatory for short options as well.

       -d, --decode
              decodes  the  status  code and asymmetric access state from each
              target port group descriptor returned. The default action is not
              to decode these values.

       -h, --help
              output the usage message then exit.

       -H, --hex
              output  response  in  hex (rather than partially or fully decode
              it).

       -r, --raw
              output response in binary to stdout.

       -v, --verbose
              increase the level of verbosity, (i.e. debug output).

       -V, --version
              print the version string and then exit.


ATTRIBUTES
       See attributes(5) for descriptions of the following attributes:


       +---------------+--------------------------+
       |ATTRIBUTE TYPE |     ATTRIBUTE VALUE      |
       +---------------+--------------------------+
       |Availability   | system/storage/sg3_utils |
       +---------------+--------------------------+
       |Stability      | Uncommitted              |
       +---------------+--------------------------+
NOTES
       The Report Target Port Groups command should be supported whenever  the
       TPGS  bits  in a standard INQUIRY response are greater than zero. [View
       with sg_inq utility.]

EXIT STATUS
       The exit status of sg_rtpg is 0 when it is  successful.  Otherwise  see
       the sg3_utils(8) man page.

AUTHORS
       Written by Douglas Gilbert.

REPORTING BUGS
       Report bugs to <dgilbert at interlog dot com>.

COPYRIGHT
       Copyright (C) 2004-2007 Christophe Varoqui and Douglas Gilbert
       This  software is distributed under a FreeBSD license. There is NO war-
       ranty; not even for MERCHANTABILITY or FITNESS FOR  A  PARTICULAR  PUR-
       POSE.

SEE ALSO
       sg_inq(sg3_utils)


       This     software     was    built    from    source    available    at
       https://java.net/projects/solaris-userland.   The  original   community
       source was downloaded from  http://sg.danny.cz/sg/p/sg3_utils-1.33.tgz

       Further information about this software can be found on the open source
       community website at http://sg.danny.cz/sg/sg3_utils.html.



sg3_utils-1.23                   January 2007                       SG_RTPG(8)