man pages section 1: User Commands

Exit Print View

Updated: July 2014
 
 

unix2dos(1)

Name

unix2dos - convert text file from ISO format to DOS format

Synopsis

unix2dos [-ascii] [-iso] [-7] 
     [-437 | -850 | -860 | -863 | -865] originalfile convertedfile

Description

The unix2dos utility converts ISO standard characters to the corresponding characters in the DOS extended character set.

This command may be invoked from either DOS or SunOS. However, the filenames must conform to the conventions of the environment in which the command is invoked.

If the original file and the converted file are the same, unix2dos will rewrite the original file after converting it.

Options

The following options are supported:

–ascii

Adds carriage returns and converts end of file characters in SunOS format text files to conform to DOS requirements.

–iso

This is the default. Converts ISO standard characters to the corresponding character in the DOS extended character set.

–7

Converts 8 bit SunOS characters to 7 bit DOS characters.

On non-i386 systems, unix2dos will attempt to obtain the keyboard type to determine which code page to use. Otherwise, the default is US. The user may override the code page with one of the following options:

–437

Use US code page

–850

Use multilingual code page

–860

Use Portuguese code page

–863

Use French Canadian code page

–865

Use Danish code page

Operands

The following operands are required:

originalfile

The original file in ISO format that is being converted to DOS format.

convertedfile

The new file in DOS format that has been converted from the original ISO file format.

Attributes

See attributes(5) for descriptions of the following attributes:

ATTRIBUTE TYPE
ATTRIBUTE VALUE
Availability
system/core-os

See also

dos2unix(1), ls(1), attributes(5)

Diagnostics

File filename not found, or no read permission

The input file you specified does not exist, or you do not have read permission. Check with the SunOS command, ls –l (see ls(1)).

Bad output filename filename, or no write permission

The output file you specified is either invalid, or you do not have write permission for that file or the directory that contains it. Check also that the drive is not write-protected.

Error while writing to temporary file

An error occurred while converting your file, possibly because there is not enough space on the current drive. Check the amount of space on the current drive using the DIR command. Also be certain that the default drive is write-enabled (not write-protected). When this error occurs, the original file remains intact.

Translated tmpfile name = filename.
Could not rename tmpfile to filename.

The program could not perform the final step in converting your file. Your converted file is stored under the name indicated on the second line of this message.