Configure RAID With a Sun Storage 6 Gb SAS PCIe Internal HBA

Language:

Use Oracle System Assistant to prepare a server hard drive for an OS installation by creating a bootable RAID 0 volume.

Before You Begin

You should have already selected a BIOS boot mode (UEFI or Legacy) from the BIOS Setup Utility.

Note - The BIOS boot mode used for the RAID configuration must match the mode that you will use when you install the operating system; otherwise, the RAID configuration will not be visible or usable.

Not all supported operating systems support UEFI mode. For a list of operating systems that support UEFI mode, see UEFI BIOS.

For instructions for switching the BIOS boot mode from UEFI to Legacy BIOS, or Legacy BIOS to UEFI, refer to Oracle X4 Series Servers Administration Guide (http://www.oracle.com/goto/x86AdminDiag/docs).

Launch Oracle System Assistant.
See Setting Up Software and Firmware Using Oracle System Assistant.

The Oracle System Assistant System Overview screen appears.
Click the Configure Hardware button, then select the RAID Configuration tab.
The RAID Configuration screen appears.
In the HBA list box, select the SGX-SAS6-INT-Z HBA.
This is the Sun Storage 6 Gb SAS PCIe Internal HBA.
In the Select RAID Level list box, select RAID-0.
In the Available Disks table, select the storage drives that you want to add to the RAID volume, and click the Create Volume button.
The Create Volume dialog box appears.
In the Create Volume dialog box:
1. (Optional) Enter the volume name.
  Entering a volume name is optional. If you do not name the volume, Oracle System Assistant creates a volume without a name.
2. Click Create.
  The Creating RAID Volume information box appears.
  
  After the volume is created, it is displayed in the Created Volumes table.
In the Details/Action column of the Created Volumes table, click the Details button.
The Volume Details dialog box appears.
In the Volume Details dialog box:
1. Review the volume details.
2. (Optional) In the Volume Name field, enter a volume name or modify it.
  If you did not enter a volume name earlier, the Volume Details dialog box gives you a second chance to do so. If you entered a volume name earlier, you can modify it here; however, you cannot delete the name entirely.
  
  Note - Naming the volume is optional. If you do not name the volume, Oracle System Assistant creates a volume without a name. Additionally, if at any time you want to change the volume name, you can do so by clicking on the Details button in the Created Volumes table; however, once a volume name is assigned, you cannot delete it.
3. Check the Set As Bootable box.
4. Click Save & Close.
  The Set Volume For Boot confirmation dialog appears.
Click OK.
The RAID Configuration screen appears and lists the RAID volume as the current boot device.
If you want to delete a volume, select it and click the Delete Volume button.
This completes the RAID configuration task.
Do one of the following:
- To select any other Oracle System Assistant task, click the corresponding button in the left panel menu. For example, after configuring RAID, you might want to select the Install OS task and perform an operating system installation.
- To return to the Oracle System Assistant System Overview screen, click System Information in the left menu panel.
- To quit Oracle System Assistant, click Exit.

Next Steps

Set Up an Operating System and Drivers