|
|
|
Processor (CPU)
|
Intel Xeon® E7-8895 v2 15-core 2.8 GHz processor.
Supported configurations:
|
|
Memory
|
Up to eight memory riser cards are supported (two risers per CPU)
in the server chassis. Each memory riser supports up to twelve
DDR3-1600 ECC low-voltage registered or load-reduced DIMMs, allowing
up to twenty-four DIMMs per processor. Installed DIMMs must be the
same type and size.
-
In a two CPU system,
you can install up to a maximum of 1.5 TB of system
memory.
-
In a four CPU system,
you can install up to a maximum of 3 TB of system
memory.
Refer to the Service Manual for DIMM
population rules and supported configurations.
|
|
Storage devices
|
For internal storage, the server chassis provides:
-
Six 2.5-inch drive bays, accessible through the front
panel. All bays can be populated with SAS-2 HDDs or SATA-3
SSDs.
-
An optional DVD+/-RW drive on the front of the server,
below the drive bays. This SATA DVD drive connects to a
USB-SATA bridge, so that the drive appears to the system as
a USB storage device.
-
SAS-2 HBA PCIe card options:
-
Sun Storage 6 Gb SAS PCIe
HBA. Supports RAID levels : 0, 1,
10.
-
Sun Storage 6 Gb SAS PCIe
RAID HBA. Supports RAID levels : 0, 1,
1E, 10, 5, 5EE, 6 with Battery Backed Write Cache
(BBWC).
|
|
USB 2.0 ports
|
-
Two ports on the front of the system and two on the
back.
-
Two internal ports on the motherboard. One port holds the
optional factory-installed Oracle System Assistant (OSA)
stick–a bootable device used to configure the server.
A second port can hold a USB flash device for system
booting.
|
|
VGA ports
|
Two high-density DB-15 video ports are available. One on the front
of the system and one on the back. The server includes an embedded
VGA 2D graphics controller with 8 MB, which supports resolutions up
to 1600 x 1200 x 16bits @ 60 Hz (1024 x 768 when viewed remotely
using Oracle ILOM Remote Console Plus RKVMS).
Note -
The VGA port available on the back panel supports VESA Device
Data Channel for monitor identification.
|
|
PCI Express 3.0 I/O slots
|
Eleven PCI Express 3.0 slots that accommodate low-profile PCIe
cards. In configurations that include a SAS HBA card, the HBA card
is installed in slot 2. All slots support x8 PCIe connections. Two
slots are also capable of supporting x16 PCIe cards.
-
Slots 1 through 7, 9, and 10: x8 connector
-
Slots 8 and 11: x8 or x16 connector
Note -
PCIe slots 7 through 11 are only functional in four CPU
systems.
|
|
PCI Express I/O cards
|
|
|
Ethernet ports
|
Four 10 GbE RJ-45 Ethernet ports on back panel.
|
|
Service processor
|
Emulex Pilot 3 baseboard management controller (BMC)
mounted on a daughterboard.
Supports industry-standard IPMI feature set.
Supports remote KVMS, USB, DVD, CD, floppy, and ISO image over
IP.
Includes a serial port.
Supports Ethernet access to SP through a dedicated RJ-45 Gigabit
Ethernet (10/100/1000) management port and optionally through one of
the host 10 GbE ports (sideband management).
|
|
Power supplies
|
Two 1030/2060 Watt AC input auto-ranging hot-swappable power
supplies.
Note -
A two-CPU system can operate with low-line 100 - 127 VAC or
high-line 200 - 240 VAC sources. A four-CPU system can only
operate with high-line 200 - 240 VAC sources.
|
|
Cooling fans
|
Six hot-swappable, redundant fans at chassis front (top-loading);
redundant fans in each power supply.
|
|
Management software
|
The following options are available:
-
Oracle Integrated Lights Out Manager (ILOM) on the service
processor.
-
Oracle System Assistant (OSA) on an optional internal USB
flash drive.
-
Oracle Hardware Management Pack on the optional OSA
internal USB flash drive.
-
Oracle Enterprise Management Ops Center, downloadable from
the Oracle site.
|