Install an NVMe Drive
The steps to install an NVMe drive are the same as the steps to install a SAS drive. For detailed instructions, see Install a SAS Drive.
Note -
After you remove an NVMe drive from the server, wait at least 10 seconds before installing a replacement drive.
-
Follow safety and ESD precautions.
See Prevent ESD Damage.
-
Remove the new drive from its packaging, and place the drive on an antistatic mat.
-
Consider your next step.
-
Align the new drive with the drive slot.
The drive is physically addressed according to the slot in which it is installed. You must install a replacement drive in the same slot as the drive that was removed.
-
Slide the drive into the slot until the drive is fully seated.
-
Rotate the air filter up until the latches click.
See Install the Filter.
-
Close the drive latch to lock the drive in place.
-
Power on the drive and attach a device driver.
See Power On an NVMe Drive and Attach a Device Driver.