Install NVMe Cables

Replacing the cable assembly is a cold-service procedure that must be performed by qualified service personnel. The server must be completely powered down before performing this procedure.

1. Install the NVMe cables between the front storage drive backplane and the motherboard.

   ---

   Caution  -  Be careful not to break any wires or base connectors when bending and folding a cable.

   ---

   1. If installing a new cable, bend it near the white tape banding, at the base connector, to conform with the cable routing.

      ---

      Tip  -  Using the handle of a small screwdriver as a form helps bend the cables while protecting the wires going into the base connectors. If necessary, the white tape banding can be split to maintain the integrity of the cable.

      ---

   2. Plug each cable into its port connector until you hear an audible click.

      The cable labeled 0-1 must be connected to the port labeled 0-1 on the motherboard, and the cable labeled 2-3 must to the port 2-3 on the motherboard.

      
      
2. Install the SAS cables.

   See Install the SAS Drive Signal Cable and Install HBA SAS Cables.

3. Install the air duct.

   See Install the Air Duct.

4. Return the server to operation.

   See Returning a Server to Operation.

Related Information

• Oracle 1.6TB NVMe SSD Documentation Library

• Component Locations (Storage, Power, NVMe, and Fan Modules)

• Component Locations (Motherboard, Memory, and PCIe Cards)

• Preparing for Service

• Returning a Server to Operation