Install a SAS Drive
Installing a SAS drive is a hot-plug operation. You do not need to power off the server before installing the drive. This procedure is the same for installing a drive filler.
-
Consider your first step.
-
If you are replacing a drive, remove the faulty or obsolete drive first, then return to this procedure, Step 3.
See Remove a SAS Drive.
-
If you are installing a new or an additional drive, go to Step 2.
-
If you are installing a drive as part of another component's service procedure, go to Step 3.
-
Review this information and complete these prerequisites in this order.
See:
-
Push the release button of the drive.
The release lever pops out.
-
Align the drive with the slot where it installs into the server.
The connector is at the rear of the drive and the release button is on the
left.
-
Press on the drive to slide the drive into the server until the release lever moves slightly inward.
-
Press the release lever fully closed with a click, securing the drive into the server.
-
Repeat from Step 3 through Step 6 for any additional drives
that you are installing.
-
Consider your next step.
-
Rotate the air filter up until the latches click.
See Install the Filter.
-
Complete these tasks to finish the service procedure.
See: