Remove the Internal HBA PCIe Card

1. Prepare for servicing.

   See Preparing for Service.

2. Locate the internal HBA card.
   
3. Using a No. 1 flat-head screwdriver, remove the bracket screw, taking care not to strip it, then carefully lift the card out of its slot.
   
4. Disconnect the SAS cables from the card, then place the card on an antistatic mat.
   
5. If you are replacing the card, use a No. 2 Philips screwdriver to remove the special fitted bracket from the faulty card.

   You must install the special fitted bracket on the replacement card. Set aside the bracket until you are ready to install the replacement card.

   
   

Related Information

• Identifying Components

• Preparing for Service

• Prevent ESD Damage