Remove the LED Board and Cable

Removing the LED board is a cold-service operation. You must power off the server before you remove the LED board.

1. Prepare for service.

   See Preparing for Service.

2. Review this information and complete these prerequisites in this order.

   See:

   • Removing the Server From the Rack

   • Remove the Filter

   • Rotate the Drive Cage to the Service Position

   • Remove the PSU Duct

   • Remove the Air Duct

3. Disconnect the LED cable from the LED assembly.
   
4. Remove the two screws securing the LED assembly to the server (requires a small Phillips screwdriver).
   
5. Lift the LED assembly from the server.
   
6. Remove the two screws securing the LED board to the LED assembly.
7. Lift the LED board from the LED assembly, and set it aside.
8. Consider your next step.
   • If replacing a faulty LED board, install a new LED board.

     See Install the LED Board and Cable.

   • If you removed the LED board as part of another component's service procedure, return to that procedure.

     See Component Service Task Reference.

Related Information

• Determine if the LED Board Is Faulty

• Install the LED Board and Cable

• Preparing for Service

• Returning a Server to Operation