Identify Disabled Components

You can run the show disabled command from the Oracle ILOM prompt to identify components that have been disabled either intentionally, by a user, or automatically, because of a fault.

1. At the Oracle ILOM prompt, type:

   -> show disabled
   Target                             | Property       | Value
   -----------------------------------+----------------+--------------------
   ...
   /SYS/MB/CMP0  | disable_reason | Configuration Rules
   ...

2. For additional information about a disabled component, type the show -t command and the Oracle ILOM target.

   See Device Paths.

   For example, type:

   -> show -t /SYS/MB/CMP0/MCU0/CH1/D0/
   Target                             | Property               | Value
   -----------------------------------+------------------------+------------
   ...
   /SYS/MB/CMP0/MCU0/CH1/D0           | type                   | DIMM
   /SYS/MB/CMP0/MCU0/CH1/D0           | ipmi name              | P0/M0/C1/D0
   /SYS/MB/CMP0/MCU0/CH1/D0           | requested_config_state | Enabled
   /SYS/MB/CMP0/MCU0/CH1/D0           | current_config_state   | Enabled
   /SYS/MB/CMP0/MCU0/CH1/D0           | disable_reason         | Configuration Rules
   /SYS/MB/CMP0/MCU0/CH1/D0           | fru_name               | 32768MB DDR4 SDRAM DIMM
   ...

   The target system paths here are examples. Your paths will vary.

Related Information

• Log In to Oracle ILOM (Service)

• Identify Faulted Components

• Device Paths

• Interpreting LEDs