Install the LED Board and Cable
Installing the LED board is a cold-service operation. You must power off the
server before installing the LED board.
-
Connect the LED cable to the LED assembly.
-
Set the LED board into the LED assembly.
-
Install and tighten the two screws.
-
Position the LED assembly over the flange, on the left of the server.
-
Install and tighten the two screws.
-
Route the cable into the cable clamp and against the server wall.
-
Connect the LED cable to the LED assembly.
-
If you installed the LED board as part of another component's removal or installation procedure, return to that procedure.
See Component Service Task Reference for assistance.
-
Review this information and complete these prerequisites in this order.
See:
-
Complete these postrequisites in this order to finish the installation
procedure.
See: