Install the USB Board
Installing the USB board is a cold-service operation. You must power off the server before installing the USB board.
-
Consider your first step.
-
Connect the cable to the motherboard and the USB board.
-
Review this information and complete these prerequisites in this order.
See:
-
Position the USB board to the location where it installs into the chassis.
The USB connectors are forward and upward.
-
Lower the USB board to the chassis, and slide the board forward over the alignment pin.
-
Compress the EMI shielding while you install and tighten the two screws.
-
Consider your next step.
-
Finish the installation procedure.
See Returning a Server to Operation.