Install an NVMe Storage Drive
The steps to physically install an NVMe storage drive are the same as the steps to
install a SAS storage drive. For detailed instructions, see Install a SAS Drive.
Note -
After you physically remove an NVMe storage drive from the server, wait at
least 10 seconds before installing a replacement drive.
-
Remove the replacement drive from its packaging, and place the drive on an
antistatic mat.
-
If necessary, remove the drive filler panel.
-
Align the replacement drive with the drive slot.
The drive is physically addressed according to the slot in which it is
installed. You must install a replacement drive in the same slot as the drive
that was removed.
-
Slide the drive into the slot until the drive is fully seated.
-
Close the drive latch to lock the drive in place.