Remove the PDB Signal Cable

Removing a cable is a cold-service operation. You must power off the server before you remove the cable.

1. Determine which cable to remove.

   See System Cable Configuration.

2. Consider your next step.

   • If you have not prepared for service, do so now.

     See Preparing for Service.

   • If you are removing a cable as part of another component's removal or installation procedure, go to Step 3.

3. Review this information, and complete these prerequisites in this order.

   • Remove the Filter

   • Remove a Fan Module

     Remove all fan modules.

   • Remove the Fan Tray

   • Rotate the Drive Cage to the Service Position

   • Remove the Air Duct

   • Remove the PSU Duct

4. Disconnect the PDB signal cable from the PDB and the motherboard connector.
   
5. Set the cable aside.
6. Consider your next step.

   • If you removed the cable as part of a replacement operation, install a new cable.

     See Install the PDB Signal Cable.

   • If you removed the cable as part of another component's removal or installation procedure, return to that procedure.

     See Component Service Task Reference for assistance.

Related Information

• Install the PDB Signal Cable

• Component Locations (Storage, Power, and Fan Modules)

• Preparing for Service

• Returning the Server to Operation