Install the DVD SATA Cable
Installing a cable is a cold-service operation. You must power off the server
before installing the cable.
-
Consider your first step.
-
If you are replacing a DVD SATA cable, remove the faulty or obsolete cable first, then return to this procedure, Step 2.
See Remove the DVD SATA Cable.
-
If you are installing a cable as part of another component's removal
or installation procedure, go to Step 2.
-
Connect the DVD SATA cable to the motherboard connector.
-
Route the DVD SATA cable to the drive backplane.
-
Review this information, and complete these prerequisites in this order.
-
Connect the DVD SATA cable to the drive backplane connector.
See System Cable Configuration.
-
Consider your next step.
-
If you installed a cable as part of a replacement operation, go to
Step 7.
-
If you installed a cable as part of another component's removal or installation procedure, return to that procedure.
See Component Service Task Reference for assistance.
-
Finish the installation procedure.
See Returning the Server to Operation.