Remove the LED Board

Removing the LED board is a cold-service operation. You must power off the server before you remove the LED board.

1. Consider your first step.

   • If you have not prepared for service, do so now. See Preparing for Service.

   • If you are removing the LED board as part of another component's removal or installation procedure, go to Step 2.

2. Review this information and complete these prerequisites in this order.

   • Removing the Server From the Rack

   • Remove the Filter

   • Rotate the Drive Cage to the Service Position

   • Remove the Air Duct

3. Disconnect the cable from the motherboard.
   
4. Remove the two screws securing the LED assembly to the chassis.
   
5. Lift the LED assembly from the chassis.
   
6. Remove the two screws securing the LED board to the LED assembly.
   
7. Lift the LED board from the LED assembly and set it aside.
8. Consider your next step.

   • If you removed the LED board as part of a replacement operation, install a new LED board. See Install the LED Board.

   • If you removed the LED board as part of another component's removal or installation procedure, return to that procedure. See Component Service Task Reference for assistance.

Related Information

• Determine if the LED Board Is Faulty

• Install the LED Board

• Preparing for Service

• Returning the Server to Operation