Remove the Backplane Data Cable

Removing a cable is a cold-service operation. You must power off the server before you remove the cable.

1. Determine location of the backplane data cable.

   See System Cable Configuration.

2. Consider your next step.

   • If you have not prepared for service, do so now.

     See Preparing for Service.

   • If you are removing a cable as part of another component's removal or installation procedure, go to Step 3.

3. Review this information, and complete these prerequisites in this order.

   • Remove a Fan Module

   • Remove the Fan Tray

4. Disconnect the backplane data cable from the drive backplane connector.

   See System Cable Configuration.

5. Disconnect the backplane data cable from the motherboard connector.
6. Set the cable aside.
7. Consider your next step.

   • If you removed a cable as part of a replacement operation, install a new cable.

     See Install the Backplane Data Cable.

   • If you removed a cable as part of another component's removal or installation procedure, return to that procedure.

     See Component Service Task Reference for assistance.

Related Information

• Install the Backplane Data Cable

• Component Locations (Storage, Power, and Fan Modules)

• Preparing for Service

• Returning the Server to Operation