|
|
|
|
1 |
Locator LED and button |
|
Activate the white
Locator LED to
find the system in a rack or datacenter. This LED provides the following indications:
Off – Normal operating state. Fast blink – System received a signal as
a result of one of the methods previously mentioned, indicating
that locating is active.
|
2 |
Service required LED |
|
When the amber
Service Required
LED is on, service is required. To detect and diagnose faults, use either the POST or ILOM
diagnostics tools. The ILOM show faulty command
provides details about any faults that cause this indicator to light.
Note - Under some fault conditions, individual component fault
LEDs are lit in addition to the system System Required LED. |
3 |
Power OK LED |
|
The green
System OK LED provides
the following indications: Off – Indicates that the
system is not running in its normal state. System power might be
on or in standby mode. The service processor might be running. Slow blink – Indicates the system is running
at a minimum level in standby and is ready to be quickly returned
to full function. The SP is running. Fast blink – Indicates that a normal transitory
activity is taking place. Fast blinking could indicate that the
system diagnostics are running, or that the system is booting. Steady on – Indicates that the system is
powered on and is running in its normal operating state. No service
actions are required.
|
4 |
Power button |
|
The recessed
Power button toggles the
system on or off. If the system host is powered off,
press once to power on. If the system is powered on, press once to initiate
a graceful system shutdown to Standby mode. If the system is powered on, press and hold for
4 seconds to initiate an emergency shutdown.
|
