-
Prepare the server for
service.
See Preparing the Server for Component Replacement.
- Locate the SAS controller HBA
on the PCI mezzanine.
The HBA is installed in the right-most slot on the PCI mezzanine.
- Remove the two
SAS cables connected to
the HBA.
- Use a No. 2 Phillips screwdriver
to remove the screw securing the HBA to the PCI mezzanine.
Save this screw for when you install a SAS controller HBA
in the slot.
- Slide the card to the left and
lift it out of the PCI mezzanine.
Set the card aside on an antistatic mat.