udaddy - pong test.
udaddy [-s server_address] [-b bind_address] [-c connections] [-C message_count] [-S message_size] [-p port_space] udaddy -s server_address [-b bind_address] [-c connections] [-C message_count] [-S message_size] [-t tos] [-p port_space]
UDADDY(1) librdmacm UDADDY(1) NAME udaddy - RDMA CM datagram setup and simple ping-pong test. SYNOPSIS udaddy [-s server_address] [-b bind_address] [-c connections] [-C message_count] [-S message_size] [-p port_space] udaddy -s server_address [-b bind_address] [-c connections] [-C message_count] [-S message_size] [-t tos] [-p port_space] DESCRIPTION Establishes a set of unreliable RDMA datagram communication paths between two nodes using the librdmacm, optionally transfers datagrams between the nodes, then tears down the communication. OPTIONS -s server_address The network name or IP address of the server system listening for communication. The used name or address must route over an RDMA device. This option must be specified by the client. -b bind_address The local network address to bind to. To bind to any address with IPv6 use -b ::0 . -c connections The number of communication paths to establish between the client and server. The test uses unreliable datagram communica- tion, so no actual connections are formed. (default 1) -C message_count The number of messages to transfer over each connection. (default 10) -S message_size The size of each message transferred, in bytes. This value must be smaller than the MTU of the underlying RDMA transport, or an error will occur. (default 100) -t tos Indicates the type of service used for the communication. Type of service is implementation dependent based on subnet configu- ration. -p port_space The port space of the datagram communication. May be either the RDMA UDP (0x0111) or IPoIB (0x0002) port space. (default RDMA_PS_UDP) ATTRIBUTES See attributes(7) for descriptions of the following attributes: +---------------+-----------------------+ |ATTRIBUTE TYPE | ATTRIBUTE VALUE | +---------------+-----------------------+ |Availability | network/open-fabrics | +---------------+-----------------------+ |Stability | Pass-through volatile | +---------------+-----------------------+ NOTES Basic usage is to start udaddy on a server system, then run udaddy -s server_name on a client system. Because this test maps RDMA resources to userspace, users must ensure that they have available system resources and permissions. See the libibverbs README file for additional details. SEE ALSO rdma_cm(7), ucmatose(1), mckey(1), rping(1) This software was built from source available at https://github.com/oracle/solaris-userland. The original community source was downloaded from ['https://www.openfabrics.org/down- loads/ibutils/ibutils-1.5.7-0.2.gbd7e502.tar.gz', 'https://www.openfab- rics.org/downloads/libibverbs/libibverbs-1.1.8.tar.gz', 'https://www.openfabrics.org/downloads/libmlx4/libmlx4-1.0.6.tar.gz', 'https://www.openfabrics.org/downloads/libsdp/lib- sdp-1.1.108-0.15.gd7fdb72.tar.gz', 'https://www.openfabrics.org/down- loads/management/infiniband-diags-1.6.5.tar.gz', 'https://www.openfab- rics.org/downloads/management/libibmad-1.3.12.tar.gz', 'https://www.openfabrics.org/downloads/management/libibu- mad-126.96.36.199.tar.gz', 'https://www.openfabrics.org/downloads/manage- ment/opensm-3.3.19.tar.gz', 'https://www.openfabrics.org/down- loads/perftest/perftest-1.3.0-0.42.gf350d3d.tar.gz', 'https://www.open- fabrics.org/downloads/qperf/qperf-0.4.9.tar.gz', 'https://www.openfab- rics.org/downloads/rdmacm/librdmacm-1.0.21.tar.gz', 'https://www.open- fabrics.org/downloads/rds-tools/rds-tools-2.0.4.tar.gz'] Further information about this software can be found on the open source community website at http://www.openfabrics.org/. librdmacm 2007-05-15 UDADDY(1)