Reset the SP (Oracle ILOM CLI)

The SP can be reset to any of the following states:

• None, which retains the existing configuration if the SP is reset.

• All, which resets the SP to the system default properties.

• Factory settings (the most severe), which resets the SP to its initial state when shipped from the factory.

Use this task to reset the SP.

• Choose the level of reset.
  • For none, type:

    -> set /SP/ reset_to_defaults=none
    Set 'reset_to_defaults' to 'none'
    ->
    

  • For all values, type:

    -> set /SP reset_to_defaults=all
    Set 'reset_to_defaults' to 'all'
    The configuration change will be applied the next time the SP is reset.
    ->
    

  • For factory defaults, type:

    -> set /SP reset_to_defaults=factory
    Set 'reset_to_defaults' to 'factory'
    The configuration change will be applied the next time the SP is reset.
    ->
    

Related Information

• Oracle ILOM CLI Overview

• Getting Oracle ILOM Help (Oracle ILOM CLI)

• Updating the Firmware

• Control Checking for SP Physical Presence (Oracle ILOM CLI)

• Display SP Information (Oracle ILOM CLI)

• Restart the SP (Oracle ILOM CLI)

• Configure the FIPS Service (Oracle ILOM CLI)