/SYS General Chassis Targets and Properties
Use the show command on these /SYS targets to
display information about and status for the chassis components. Use the
set command to configure the
clear_fault_action, load_uri,
and value properties to manually clear a fault, load
firmware, or turn on the Locate LED, respectfully.
Note -
Properties indicated as Not Supported or
N/A are not listed.
|
|
|
|
/SYS
|
-
type = Host System
-
ipmi_name = SYS
-
product_name = unknown
-
product_part_number =
unknown
-
product_serial_number =
unknown
-
product_manufacturer = Oracle
Corporation
-
fault state = OK
-
clear_fault_action =
(none)
-
power_state = On
|
Sensors and FRU information.
|
|
/SYS/FMx
|
|
Fan module x management.
|
|
/SYS/FMx/FANy
|
|
Fan y management for fan module
x.
|
|
/SYS/FMx/FANy/TACH
|
|
Fan y speed in fan module
x.
|
|
/SYS/FMx/PRSNT
|
-
type = Entity Presence
-
ipmi_name =
FMx/PRSNT
-
class = Discrete
Sensor
-
value = Present
-
alarm status = cleared
|
Presence and alarm status of fan module
x.
|
|
/SYS/OK
|
-
type = Indicator
-
ipmi_name = OK
-
value = On
|
OK LED information.
|
|
/SYS/SERVICE
|
-
type = Indicator
-
ipmi_name = SERVICE
-
value = Off
|
Service LED information.
|
|
/SYS/SP
|
-
type = Service
Processor
-
ipmi_name = SERVICE
-
fru_description = PCA, PILOT3 SP,
OPUS
-
fru_manufacturer = Oracle
Corporation
-
fru_part_number =
7096151
-
fru_rev_level = 04
-
fru_serial_number =
489090M+14516P002F
-
fault_state = OK
-
clear_fault_action =
(none)
|
Service processor information.
|
|
/SYS/SP/OK
|
-
type = Indicator
-
ipmi_name = SP/OK
-
value = On
|
SP LED information.
|
|